



The Thor Fiber portable F-1GPS-TX/RX systems are available to support the remote location of industrial GPS antennas. These kits are assembled and tuned to the unique requirements of each application. Thor GPS over fiber systems are an excellent solution for distance limitation between maritime or government GPS antennas and radio signal receiver equipment. Typically any sensor equipment or tuning hardware such as universal time receivers or GPS navigation gear must be installed and located within 100 ft of the antenna system. Most modern industrial type systems require antennas with a clear view of the horizon to function properly. In the case of large ocean going vessels, underground military installations, or large buildings or structures(metropolis); it can be a challenge to install GPS equipment within 100 ft of a suitable antenna location. Thor solves this problem by extending the distance to over 20km by converting the GPS signal from the antenna's coax to fiber optic cable.GPS reference timing signals are widely used to synchronize cellular base stations.GPS systems typically consist of an active rooftop antenna, a GPS receiver and a length of coaxial cable to connect them. Common challenges arise when the distance between the rooftop antenna and the cellular base station equipment (usually in the basement) is greater than 300 ft. Coaxial cable runs over 300 ft are not practical for most GPS receiver systems, so a fiber optic link is required at such distances, and Thor Fiber optic links are some of the most trusted, cost-effective links in the industry.Features:Supports all GPS frequencies internationallySupports L1 at 1575.42 MHz, L2 at 1227.60 MHz, L3 at 1381.05Mhz, L4 at 1379.913Mhz and L5 at 1176.45 MHz, L6 at 1278.75Mhz, L7 at 1267.6Mhz GPS bandsExtends the range between GPS antennas and equipment to over 20 milesFiber links are immune to RF interference problems associated with coaxIdeal for broadcasting towers, cell sites, military installations, and large shipsProvides a fiber security break and insulates from lightning strikes1 GPS input1 Independent fiber optic ouput SC/APCN Female Type RF ConnectorPortable power supplySupports high level of optical split and RF split for flexible routing of GPS for small cells and extended base station sitesSimple to install - no adjustmentMinimal signal loss and degradation over very long cable runs upto 20km.Provides a highly secure tamper-proof GPS over fiber connection between antenna and receiver.Interference free link through noisy environments, the optical signal is unaffected by electrical noise.Electrical isolation between antenna and recever protects against lightning strikes and electrical surgeSelectable GPS antenna powering voltageSupports all L2 & L1& L5 GPS bandsThe transmitter receiver Kit comes with 110-220V AC to DC power supplyGPS base stations with long antenna cable runsRun the GPS carrier to multiple GPS timing boards throughout a companyRun GPS throughout an aircraftSatisfies the requirement of supplying multiple GPS receivers with a carrier, spread over a great distanceFor R&D facilities, supplies a GPS carrier to a multitude of engineers and technicians with only one antenna on the roof.DAS, WiMax, Satcom, LTE over fiberTt is very important to interface unit with SC/APC - Angle Polished Connector to avoid any light reflections.If your fiber is terminated with the SC, ST, FC /PC flat connector, you need to use an optical jumper from PC type to SC/APC for proper conversion.
Price now:
From
To
Price History:
Details:The Thor Fiber portable F-1GPS-TX/RX systems are available to support the remote location of industrial GPS antennas. These kits are assembled and tuned to the unique requirements of each application. Thor GPS over fiber systems are an excellent solution for distance limitation between maritime or government GPS antennas and radio signal receiver equipment. Typically any sensor equipment or tuning hardware such as universal time receivers or GPS navigation gear must be installed and located within 100 ft of the antenna system. Most modern industrial type systems require antennas with a clear view of the horizon to function properly. In the case of large ocean going vessels, underground military installations, or large buildings or structures(metropolis); it can be a challenge to install GPS equipment within 100 ft of a suitable antenna location. Thor solves this problem by extending the distance to over 20km by converting the GPS signal from the antenna's coax to fiber optic cable.GPS reference timing signals are widely used to synchronize cellular base stations.GPS systems typically consist of an active rooftop antenna, a GPS receiver and a length of coaxial cable to connect them. Common challenges arise when the distance between the rooftop antenna and the cellular base station equipment (usually in the basement) is greater than 300 ft. Coaxial cable runs over 300 ft are not practical for most GPS receiver systems, so a fiber optic link is required at such distances, and Thor Fiber optic links are some of the most trusted, cost-effective links in the industry.Features:Supports all GPS frequencies internationallySupports L1 at 1575.42 MHz, L2 at 1227.60 MHz, L3 at 1381.05Mhz, L4 at 1379.913Mhz and L5 at 1176.45 MHz, L6 at 1278.75Mhz, L7 at 1267.6Mhz GPS bandsExtends the range between GPS antennas and equipment to over 20 milesFiber links are immune to RF interference problems associated with coaxIdeal for broadcasting towers, cell sites, military installations, and large shipsProvides a fiber security break and insulates from lightning strikes1 GPS input1 Independent fiber optic ouput SC/APCN Female Type RF ConnectorPortable power supplySupports high level of optical split and RF split for flexible routing of GPS for small cells and extended base station sitesSimple to install - no adjustmentMinimal signal loss and degradation over very long cable runs upto 20km.Provides a highly secure tamper-proof GPS over fiber connection between antenna and receiver.Interference free link through noisy environments, the optical signal is unaffected by electrical noise.Electrical isolation between antenna and recever protects against lightning strikes and electrical surgeSelectable GPS antenna powering voltageSupports all L2 & L1& L5 GPS bandsThe transmitter receiver Kit comes with 110-220V AC to DC power supplyGPS base stations with long antenna cable runsRun the GPS carrier to multiple GPS timing boards throughout a companyRun GPS throughout an aircraftSatisfies the requirement of supplying multiple GPS receivers with a carrier, spread over a great distanceFor R&D facilities, supplies a GPS carrier to a multitude of engineers and technicians with only one antenna on the roof.DAS, WiMax, Satcom, LTE over fiberTt is very important to interface unit with SC/APC - Angle Polished Connector to avoid any light reflections.If your fiber is terminated with the SC, ST, FC /PC flat connector, you need to use an optical jumper from PC type to SC/APC for proper conversion.
Price now:
From
To
This site contains affiliate links for which we may be compensated.
Selectum LLC
0.00% (~ $$v)
New
$1,495.00
The Thor Fiber portable F-1GPS-TX/RX systems are available to support the remote location of industrial GPS antennas. These kits are assembled and tuned to the unique requirements of each application. Thor GPS over fiber systems are an excellent solution for distance limitation between maritime or government GPS antennas and radio signal receiver equipment. Typically any sensor equipment or tuning hardware such as universal time receivers or GPS navigation gear must be installed and located within 100 ft of the antenna system. Most modern industrial type systems require antennas with a clear view of the horizon to function properly. In the case of large ocean going vessels, underground military installations, or large buildings or structures(metropolis); it can be a challenge to install GPS equipment within 100 ft of a suitable antenna location. Thor solves this problem by extending the distance to over 20km by converting the GPS signal from the antenna's coax to fiber optic cable.GPS reference timing signals are widely used to synchronize cellular base stations.GPS systems typically consist of an active rooftop antenna, a GPS receiver and a length of coaxial cable to connect them. Common challenges arise when the distance between the rooftop antenna and the cellular base station equipment (usually in the basement) is greater than 300 ft. Coaxial cable runs over 300 ft are not practical for most GPS receiver systems, so a fiber optic link is required at such distances, and Thor Fiber optic links are some of the most trusted, cost-effective links in the industry.Features:Supports all GPS frequencies internationallySupports L1 at 1575.42 MHz, L2 at 1227.60 MHz, L3 at 1381.05Mhz, L4 at 1379.913Mhz and L5 at 1176.45 MHz, L6 at 1278.75Mhz, L7 at 1267.6Mhz GPS bandsExtends the range between GPS antennas and equipment to over 20 milesFiber links are immune to RF interference problems associated with coaxIdeal for broadcasting towers, cell sites, military installations, and large shipsProvides a fiber security break and insulates from lightning strikes1 GPS input1 Independent fiber optic ouput SC/APCN Female Type RF ConnectorPortable power supplySupports high level of optical split and RF split for flexible routing of GPS for small cells and extended base station sitesSimple to install - no adjustmentMinimal signal loss and degradation over very long cable runs upto 20km.Provides a highly secure tamper-proof GPS over fiber connection between antenna and receiver.Interference free link through noisy environments, the optical signal is unaffected by electrical noise.Electrical isolation between antenna and recever protects against lightning strikes and electrical surgeSelectable GPS antenna powering voltageSupports all L2 & L1& L5 GPS bandsThe transmitter receiver Kit comes with 110-220V AC to DC power supplyGPS base stations with long antenna cable runsRun the GPS carrier to multiple GPS timing boards throughout a companyRun GPS throughout an aircraftSatisfies the requirement of supplying multiple GPS receivers with a carrier, spread over a great distanceFor R&D facilities, supplies a GPS carrier to a multitude of engineers and technicians with only one antenna on the roof.DAS, WiMax, Satcom, LTE over fiberTt is very important to interface unit with SC/APC - Angle Polished Connector to avoid any light reflections.If your fiber is terminated with the SC, ST, FC /PC flat connector, you need to use an optical jumper from PC type to SC/APC for proper conversion.
General | |
|---|---|
Size | 1m |
Brand | Thor Broadcast |
Color | light |
Gender | female |
Sellers offer a range of delivery options, so you can choose the one that’s most convenient for you. Many sellers offer free delivery. You can always find the postage cost and estimated delivery date in a seller’s listing. You'll then be able to see a full list of delivery options during checkout. These can include: Express delivery, Standard delivery, Economy delivery, Click & Collect, Free local collection from seller.
Your options for returning an item vary depending on what you want to return, why you want to return it, and the seller's return policy. If the item is damaged or doesn't match the listing description, you can return it even if the seller's returns policy says they don't accept returns. If you've changed your mind and no longer want an item, you can still request a return, but the seller doesn't have to accept it. If the buyer changes their mind about a purchase and wants to return an item, they may need to pay return postage costs, depending on the seller's return policy. Sellers can provide a return postage address and additional return postage information for the buyer. Sellers pay for return postage if there's a problem with the item. For example, if the item doesn't match the listing description, is damaged or defective or is counterfeit. By law, customers in the European Union also have the right to cancel the purchase of an item within 14 days beginning from the day you receive, or a third party indicated by you (other than the carrier) receives, the last good ordered by you (if delivered separately). This applies to all products except for digital items (e.g. Digital Music) that are provided immediately to you with your acknowledgment, and other items such as video, DVD, audio, video games, Sex and Sensuality products and software products where the item has been unsealed.
Sellers have to offer a refund for certain items only if they are faulty, such as: Personalized items and custom-made items, Perishable items, Newspapers and magazines, Unwrapped CDs DVDs and computer software. If you used your PayPal balance or bank account to fund the original payment, the refunded money will go back to your PayPal account balance. If you used a credit or debit card to fund the original payment, the refunded money will go back to your card. The seller will effect the refund within three working days but it may take up to 30 days for Paypal to process the transfer. For payments funded partially by a card and partially by your balance/bank, the money taken from your card will go back to your card and the remainder will return to your PayPal balance.